Study › General › G1E › G1E08

G1E08

COMMISSION'S RULES · - Control categories; repeater regulations; third-party rules; ITU regions; automatically controlled digital station

G1E08§ 97.313(j)G1E →

What is the maximum PEP output allowed for spread spectrum transmissions?

  1. A100 milliwatts
  2. B10 watts
  3. C100 watts
  4. D1500 watts
Why Section 97.313(j) caps spread spectrum (SS) emissions at 10 watts PEP output. Spread spectrum spreads energy over a wide bandwidth, so the FCC limits power to keep interference to narrowband users low, and because SS links are typically short-range data or experimental work. This is one of several special power limits in 97.313 that sit well below the general 1500 W PEP ceiling.
Watch out The choice that says 1500 watts is the general maximum for most modes under 97.313(b), not for spread spectrum; 100 milliwatts is a common Part 15 unlicensed level, not an amateur SS limit.
Spread Spectrum = Small: 10 watts PEP, not 1500.
HamSandwich explanation, first draft. The question and answers are the NCVEC text.
47 CFR 97.313(j) Transmitter power standards.

(a) An amateur station must use the minimum transmitter power necessary to carry out the desired communications.

(b) No station may transmit with a transmitter power exceeding 1.5 kW PEP.

(c) No station may transmit with a transmitter power output exceeding 200 W PEP:

(1) On the 10.10-10.15 MHz segment;

(2) On the 3.525-3.60 MHz, 7.025-7.125 MHz, 21.025-21.20 MHz, and 28.0-28.5 MHz segment when the control operator is a Novice Class operator or a Technician Class operator; or

(3) The 7.050-7.075 MHz segment when the station is within ITU Regions 1 or 3.

(d) No station may transmit with a transmitter power exceeding 25 W PEP on the VHF 1.25 m band when the control operator is a Novice operator.

(e) No station may transmit with a transmitter power exceeding 5 W PEP on the UHF 23 cm band when the control operator is a Novice operator.

(f) An Earth station or telecommand station may transmit on the 435-438 MHz segment with a maximum of 611 W effective radiated power (1 kW equivalent isotropically radiated power). The transmitting antenna elevation angle between the lower half-power (−3 dB relative to the peak or antenna bore sight) point and the horizon must always be greater than 10°. No other station may transmit with a transmitter power exceeding 50 W PEP on the UHF 70 cm band from an area specified in § 2.106(c)(270)(i) of this chapter, unless expressly authorized by the FCC after mutual agreement, on a case-by-case basis, between the Regional Director of the applicable field facility and the military area frequency coordinator at the applicable military base.

(g) No station may transmit with a transmitter power exceeding 50 W PEP on the 33 cm band from within 241 km of the boundaries of the White Sands Missile Range. Its boundaries are those portions of Texas and New Mexico bounded on the south by latitude 31°41′ North, on the east by longitude 104°11′ West, on the north by latitude 34°30′ North, and on the west by longitude 107°30′ West.

(h) No station may transmit with a transmitter power exceeding 50 W PEP on the 219-220 MHz segment of the 1.25 m band.

(i) 60 m band power requirements: No station may transmit on the frequencies 5.332, 5.348, 5.373, and 5.405 MHz in the 60 m band with a radiated power exceeding 100 W ERP. No station may transmit in the 5.3515-5.3665 MHz band with a radiated power exceeding 9.15 W ERP. For the purpose of computing ERP, the transmitter PEP will be multiplied by the antenna gain relative to a half-wave dipole antenna. A half-wave dipole antenna will be presumed to have a gain of 1 (0 dBd). Licensees using other antennas must maintain in their station records either the antenna manufacturer's data on the antenna gain or calculations of the antenna gain.

(j) No station may transmit with a transmitter output exceeding 10 W PEP when the station is transmitting a SS emission type.

(k) No station may transmit in the 135.7-137.8 kHz (2200 m) band with a transmitter power exceeding 1.5 kW PEP or a radiated power exceeding 1 W EIRP.

(l) No station may transmit in the 472-479 kHz (630 m) band with a transmitter power exceeding 500 W PEP or a radiated power exceeding 5 W EIRP, except that in Alaska, stations located within 800 kilometers of the Russian Federation may not transmit with a radiated power exceeding 1 W EIRP.

(m) No station may transmit with a peak equivalent isotropically radiated power (EIRP) exceeding 316 W in the 76-81 GHz (4 mm) band.

eCFR text as of 1 Sep 2026 · read on ecfr.gov
← G1E07 All of G1E G1E10 →

The rest of G1E

  1. G1E01 Which of the following would disqualify a third party from participating in sending a message via an amateur …
  2. G1E02 When may a 10-meter repeater retransmit the 2-meter signal from a station that has a Technician class control…
  3. G1E03 What is required to conduct communications with a digital station operating under automatic control outside t…
  4. G1E04 Which of the following conditions require a licensed amateur radio operator to take specific steps to avoid h…
  5. G1E05 What are the restrictions on messages sent to a third party in a country with which there is a Third-Party Ag…
  6. G1E06 The frequency allocations of which ITU region apply to radio amateurs operating in North and South America?
  7. G1E07 In what part of the 2.4 GHz band may an amateur station communicate with non-licensed Wi-Fi stations?
  8. G1E08 What is the maximum PEP output allowed for spread spectrum transmissions?
  9. G1E10 Why should an amateur operator normally avoid transmitting on 14.100, 18.110, 21.150, 24.930 and 28.200 MHz?
  10. G1E11 On what bands may automatically controlled stations transmitting RTTY or data emissions communicate with othe…
  11. G1E12 When may third-party messages be transmitted via remote control?
MFJ-259D HF/VHF Antenna AnalyzerSponsored · View on Amazon →RG-213 Coax Cable 75ft with PL259 ConnectorsSponsored · View on Amazon →