HamSandwich

Fresh cut ham data, daily.

Study › Amateur Extra › E6E › E6E06

E6E06

CIRCUIT COMPONENTS · Semiconductor materials and packages for RF use

E6E06E6E →

What characteristics of MMICs make them a popular choice for VHF through microwave circuits?

  1. AThe ability to retrieve information from a single signal, even in the presence of other strong signals
  2. BExtremely high Q factor and high stability over a wide temperature range
  3. CNearly infinite gain, very high input impedance, and very low output impedance
  4. DControlled gain, low noise figure, and constant input and output impedance over the specified frequency range
Why An MMIC (monolithic microwave integrated circuit) is a complete amplifier stage built on one semiconductor chip, usually in a small package with input, output, ground and bias leads. Its internal matching networks are designed for a fixed system impedance, typically 50 ohms, at both input and output across its rated band, so you can cascade stages without designing matching networks. Combined with a specified flat gain and a low noise figure, that makes VHF, UHF and microwave amplifier design almost a matter of adding a bias resistor and blocking capacitors.
Watch out The choice with nearly infinite gain, very high input impedance and very low output impedance is the description of an ideal operational amplifier, not an MMIC; the extremely high Q answer describes a resonator or crystal.
MMIC = plug-and-play 50 ohm gain block: fixed gain, low noise, matched in and out.
HamSandwich explanation, first draft. The question and answers are the NCVEC text.
← E6E05 All of E6E E6E07 →

The rest of E6E

  1. E6E01 Why is gallium arsenide (GaAs) useful for semiconductor devices operating at UHF and higher frequencies?
  2. E6E02 Which of the following device packages is a through-hole type?
  3. E6E03 Which of the following materials supports the highest frequency of operation when used in MMICs?
  4. E6E04 Which is the most common input and output impedance of MMICs?
  5. E6E05 Which of the following noise figure values is typical of a low-noise UHF preamplifier?
  6. E6E06 What characteristics of MMICs make them a popular choice for VHF through microwave circuits?
  7. E6E07 What type of transmission line is often used for connections to MMICs?
  8. E6E08 How is power supplied to the most common type of MMIC?
  9. E6E09 Which of the following component package types have the least parasitic effects at frequencies above the HF r…
  10. E6E10 What advantage does surface-mount technology offer at RF compared to using through-hole components?
  11. E6E11 What is a characteristic of DIP packaging used for integrated circuits?
  12. E6E12 Why are DIP through-hole package ICs not typically used at UHF and higher frequencies?
Baofeng BF-F8HP Pro Dual Band HandheldSponsored · View on Amazon →Yaesu FT-65R VHF/UHF Dual Band HandheldSponsored · View on Amazon →